top of page

decor Weave 

How To Guide

Hokus Pokus new “Décor-Weave”  can be applied to natural wood, painted furniture or a surface of your choice.

Requirements for Application

  • A piece of furniture or project which has been completed to a smooth finish, painted or sanded natural wood

  • Décor-weave Design

  • Paint brush

  • Brayer

  • Water-based sealer 

  • 400 grit sandpaper

  • Clean, wet cloth

  • Iron 

 

With the iron on a COOL, DRY (NOT STEAM) setting, gently iron the back of your Décor-Weave design to remove initial fold lines. 

 

The prepared furniture piece: wipe down with a wet cloth to remove all the dust. 

It is vitally important to remove all excess dust before applying any Hokus Pokus Décor-Weave to your project. Splinters or chipped paint, no matter how small, can spoil the surface and texture of your Décor-Weave project. 

 

All painted surfaces must be 100% dry to avoid the Hokus Pokus Décor-Weave from lifting or creating air bubbles. 

 

Always plan beforehand where you are going to place your Hokus Pokus Décor-Weave and cut to size, if needed.

Applying the Décor-weave: Apply a base coat of a good quality polyurethane water-based sealer, while still wet, place the Hokus Pokus Décor-Weave in the desired place, ensure all air bubbles are removed by rolling with a brayer.

Wait about 30 min then apply a 1st coat of sealer over the Hokus Pokus Décor-Weave, wait until 100% dry then apply a 2nd coat and 3rd coat, ensure the surface is completely dry as per manufacturer’s instructions – don’t rush this phase.

 

Once 100% dried and cured, gently sand the whole design with 400 grit sandpaper to a smooth texture. Clean with a wet cloth. 

bottom of page