How To Guide & Application
-
This product will not bend & will be brittle when cold
-
Warm up the decor trim before applying the glue.
-
Keep the trim warm by adding more heat with the hairdryer as you work through your project
-
Deco-Curve DIY can be cut with a craft knife
What You Need
-
Wood glue
-
Hair dryer, Microwave, Heat gun
-
Your Deco-Curve moulding
-
Kitchen Roll / wet cloth (in case things get messy)
-
Clean Your Surface – make sure your surface is free from flaking paint or dirt.
-
-
Heat your DecoCurve – depending on the size and thickness of your mould this could take a few seconds to nearly a minute. Heat with a microwave, hairdryer, heat gun.
-
-
TIP: - If using a Microwave start with 08 -10 seconds, this should be sufficient, add 5 seconds at a time if further heating is needed. Do not overheat.
-
-
Apply The Glue – apply a strong wood glue, an average amount is fine, not too much to create over spill once stuck down.
-
-
Press the Moulding against the area that you want to apply it to.
-
-
Apply more heat if the moulding has cooled down too much. Hold in place for a couple of minutes or apply a low tack tape to hope in place. Adding heat will ensure a good adhesion
-
-
TIP: wipe away any excess glue that has spilled out. It is easily wiped away using a baby wipe, damp cloth, kitchen roll, cotton buds or even your fingers.